Panasonic KX-TD500, Programming Manual

Page: 86 / 392

System
86 Programming Guide
Parameter Call Parking Recall Time
Default 60 s
Value Range 0-1800 s
Description/Function Specifies the length of time in seconds the system is to wait before
alerting (Call Parking Recall) the extension who parked the call.
Note
• If "0" is specified, Call Parking Recall does not occur.
Reference • 1.10 Holding Features (F/G)
– Call Park
• 2.4.1 Holding a Call (U/M)
Parameter TIE Inter-digit Time
Default 5 s
Value Range 3-30 s
Description/Function Specifies the maximum time allowed between digits on a TIE call
after it was received by the system.
Reference • 3.1 TIE Line Features (F/G)
– TIE Line Service
Parameter DISA Prolong Time
Default 3 min
Value Range 0-7 min
Description/Function A CO-to-CO line call duration is initially limited by "CO-to-CO
Line Call Duration Time." However, prolonging the CO-to-CO line
call duration is possible. To prolong the call duration, the caller
should press any dialpad key except . The amount of prolonging
is set by "DISA Prolong Time" ( 0-7 minutes). (If this is set to zero,
then prolonging is disabled.) Depending on "13. DISA prolong
operation" setting in Section "2.8
System Option," the call
duration can be prolonged 10 times or without limit.
Reference • 1.5 Attended Features (F/G)
– Direct Inward System Access (DISA)