Useful Information
35
Telephone
Problem
Cause & solution
I cannot make or receive calls.
L
The AC adaptor or telephone line cord is not connected.
Check the connections.
L
If you are using a splitter to connect the unit, remove the
splitter and connect the unit to the wall socket directly. If
the unit operates properly, check the splitter.
L
Disconnect the base unit from the telephone line and
connect the line to a known working telephone. If the
working telephone operates properly, contact our service
personnel to have the unit repaired. If the working
telephone does not operate properly, contact your service
provider.
L
The call bar feature is turned on. Turn it off (Seite 19).
L
You dialled a call restricted number (Seite 24).
L
The key lock feature is turned on. Turn it off (Seite 11).
The unit does not ring.
L
The ringer volume is turned off. Adjust the handset ringer
volume (Seite 17) and the base unit ringer volume (Seite
22).
L
The night mode feature is turned on. Turn it off (Seite 17,
22).
The batteries should be charging but
the battery icon does not change.
L
Clean the charge contact and charge again (Seite 8).
L
The AC adaptor is disconnected. Plug in the AC adaptor.
A busy tone is heard when
{C}
is
pressed.
L
The handset is too far from the base unit. Move closer
and try again.
L
Another handset is on an outside call. Wait for the other
user to complete the call.
Static is heard, sound cuts in and out.
Interference from other electrical units.
L
Locate the handset and the base unit away from other
electrical appliances.
L
Move closer to the base unit.
The handset stops working while being
used.
L
Disconnect the AC adaptor and turn off the handset.
Connect the AC adaptor, turn on the handset and try
again.
While storing an entry in the
phonebook or assigning a one touch
dial, the handset starts to ring.
L
A call is being received. To answer the call, press
{C}
.
Programming will be cancelled. Start again.
Pressing
{R}
does not display/dial
the last number dialled.
L
The redialled number was more than 24 digits long.
Redial the number manually.
The handset beeps intermittently
and/or
7
flashes.
L
Fully charge the batteries (Seite 8).
I fully charged the batteries, but
7
still flashes.
L
Clean the charge contact and charge again (Seite 8).
L
It is time to replace the batteries (Seite 9).
Caller information is not displayed.
L
You must subscribe to Caller ID service.
TCD200G(e-g).book Page 35 Tuesday, February 8, 2005 8:57 AM
