Panasonic KX-TCD150FXB, Service Manual

Page: 27 / 77

8.2.1. Preparation
8.2.2.2. PC Setting
8.2. The Setting Method of JIG (Base Unit)
8.2.1.1. Equipment Required
·
DECT tester: Rohde & Schwarz, CMD 60 is recommended.
·
Frequency counter: it must be precise to be able to measure 1Hz (precision; ±4ppm).
Hewlett Packard, 53131A is recommended.
·
DC power: it must be able to output at least 1A current under 9V.
·
Digital multi-meter (DMM): it must be able to measure voltage and current.
· Oscilloscope
8.2.1.2. JIGs and PC
· EEPROM serial JIGs
1. I2C PCB: PQZZTCD420BX
2. RS232C cable: PQZZ1CD705BX
3. Clip cable: PQZZ2CD705BX
4. DC cable: PQZZ3CD705BX
·
PC which runs in DOS mode
· Batch file CD-ROM for setting: PQZZTCD150FX
8.2.2. PC Setting
8.2.2.1. Connections
1. Open a window of MS-DOS mode from the start-up menu.
2. Change a directory to the one with “RTX_COM” contained.
3. Type “SET RTX_COM=1” from the keyboard (when COM port 1 is used for the connection).
4. Type “doskey”.
Note:
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from
address “00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E
98” is written.
setfreq adjust Frequency of RFIC Type “setfreq nn nn”.
hookoff off-hook mode on Base Type “hookoff”.
hookon on-hook mode on Base Type “hookon”.
Getchk Read checksum Type “getchk”.
Wreeprom write eeprom Type “wreeprom 01 23 45". “01 23" is address and “45”
is data to be written.
InitBsPIN.bat Initial Base PIN to “0000” Type “initBsPIN”
27
KX-TCD150FXB / KX-TCD150FXC / KX-TCD152FXB / KX-TCA115EXB / KX-TCA115EXC