background image

Important Safety Instructions

When using your telephone
equipment, basic safety
precautions should always be
followed to reduce the risk of fire,
electric shock and injury to
persons, including the following:

1. Read and understand all

instructions.

surface. This product should
never be placed near or over
a radiator or heat register.
This product should not be
placed in a built-in installation
unless proper ventilation is
provided.

2. Follow all warnings and

instructions marked on the
product.

3. Unplug this product from the

wall outlet before cleaning.
Do not use liquid cleaners or
aerosol cleaners. Use a damp
cloth for cleaning.

Do not use this product near

water, for example, near a
bath tub, wash bowl, kitchen
sink, or laundry tub, in a wet
basement, or near a
swimming pool.

Do not place this product on
an unstable cart, stand, or
table. The product may fall,
causing serious damage to
the product.

7

9

10

Slots and openings in the
cabinet and the back or

 are provided for

ventilation, to protect it from
overheating, these openings

must not be blocked or

covered. The openings
should never be blocked by
placing the product on the

bed. sofa, rug, or other 

 , _

Do not allow anything to rest
on the telephone cord. Do not
locate this product where the
cord will be abused by
persons walking on it.

Do not overload wall outlets

and extension cords as this
can result in the risk of fire or
electric shock.

Never push objects of any
kind into this product through
cabinet slots as they may
touch dangerous voltage
points or short out parts that
could result in a risk of fire or
electric shock. Never spill
liquid of any kind on the
product.

To reduce the risk of electric
shock, do not disassemble
this product, but take it to a
qualified serviceman when
some service or repair work is
required. Opening or
removing covers may expose
you to dangerous voltages or
other risks. Incorrect
reassembly can cause
electric shock when the
appliance is subsequently
used.

11. Unplug this product from the

wall outlet and refer servicing

to qualified 

 personnel

under the following conditions:

A. When the power supply

cord or plug is damaged
or frayed.

B. If liquid has been spilled

into the product.

C. If the product has been

exposed to rain or water.

D. If the product does not

operate normally by

following the operating

instructions. Adjust only

those controls, that are

covered by the operating
instructions because
improper adjustment of

other controls may result in

damage and will often
require extensive work by
a qualified technician lo
restore the product to
normal operation.

12

13

E. If the product has been

dropped or the cabinet has
been damaged.

F. If the product exhibits a

distinct change in
performance.

Avoid using a telephone

(other than a cordless type)

during an electrical storm
There may be a remote risk of
electric shock from lightning.

Do not use the telephone to
report a gas leak in the

vicinity of the leak.

SAVE THESE

INSTRUCTIONS

Summary of Contents for KX-T7050







Reviews:

Related manuals for KX-T7050