Panasonic KX-PS8000, Reference Manual

Page: 140 / 155

140
Error message Possible cause Recovery
ASPI Manager is not
found. Install ASPI for
Windows. (e.g. install
wnaspi32.dll to your
windows(system
directory.)
Troubleshooting
Can not find Panasonic
KX-PS8000. Make sure
that Panasonic KX-
PS8000 is connected to
your PC by SCSI, and
then retry again. Perform the following procedure.
1. Confirm that the terminator is correctly
set.
2. Confirm that the printer is ready.
3. Confirm that the printer is correctly
connected with a SCSI cable.
4. Turn off the computer, then turn it on
again.
Printer Driver for Windows 95
Correctly install SCSI board and its driver.
(Refer to the instructions manual of the
SCSI board.)
wnaspi32.dll will be installed or replaced
with a new version.
SCSI board and its driver are not
installed correctly.
B
Cable connection is improper or
printer is not ready.
B
The terminator setting is
improper.
The ASPI manager
installed on this PC does
not support Windows.
Install ASPI for Windows.
[e.g. install wnaspi32.dll
to your windows (system
directory)].
Can not initialize ASPI for
Windows. Install newer
version of ASPI for
Windows
The ASPI for Windows
installed on this PC does
not have expected
function. Install newer
version of ASPI for
Windows.
SCSI board and its driver are not
installed correctly. Correctly install the SCSI board and its
driver. (Refer to the instructions manual of
the SCSI board.)
wnaspi32.dll will be installed or replaced
with a new version.
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
( ☞ P.147) .
The ASPI for Windows
installed on this PC does
not support expected
mode. Install newer
version of ASPI for
Windows.