Panasonic KX-NS1000, Programming Manual

Page: 79 / 1182

5.
Click Execute .
The programme files are updated to the specified PBXs.
Note
•
Updated PBXs reset when the update is complete.
•
If this operation is performed when logged in to a Slave unit only the PBX mother board and hardware
specifically registered to the Slave unit may be updated.
Timed Update (Automatic update)
Specify which cards or devices to update and a time to execute the update.
1.
In Email notification , specify up to 2 e-mail addresses that will receive a notification when programme
files have been updated.
2.
Updated programme files that can be used to update cards or devices installed in the system are listed in
Available Program File(s) . In Select the target to update , specify which cards or devices will be updated
using the files listed by checking the boxes next to each item.
Note
When selecting an item, a warning message may be displayed. Confirm the contents of the warning,
and then click
OK to continue.
3.
In Update Time , specify the time of day when the update will be executed.
4.
Click Apply .
5.
Click on another PBX site tab to programme another PBX in the One-look network as required, and then
repeat steps
1 – 4 . Perform settings for each PBX in the One-look network as required.
6.
Click Execute .
The programme files will be updated to the specified PBXs at the specified time.
Note
•
All PBXs in a One-look network must be using the same version of the software. When updating PBXs
connected in a One-look network, note the following:
–
Apply the same version of the software update to all the PBXs in the One-look network.
–
When updating the programme files for multiple PBXs, an immediate (manual) update is
recommended. For Automatic (timed) updates, set the same
Update Time for all PBXs in the
One-look network.
•
At most, the process of updating all PBXs in the network can take approximately 30 minutes to
complete.
•
For CS programme files, in order for CS cards to be displayed on this screen, the cards must be set
to INS, and the ports of the card must be set to OUS.
PC Programming Manual 79
5.1.2 System Control—Program Update—Update Program File