Panasonic KX-HNS105, Installation Manual

Page: 10 / 32

Installation
Mount the siren on a wall using the
holes in the rear cover.
Note:
R The strobe light flashes when the
siren sounds. Mount the siren in a
location where its strobe light will be
visible.
R Mount the siren on the stable
location where the siren can be
adequately supported when
mounting.
R Mount the siren securely to a wall.
Vibrations may cause it to fall if it is
not secured.
R Do not mount siren on a soft
material. It may fall down, break or
cause injury.
R Do not mount the siren on the
following places: gypsum board,
ALC (autoclaved lightweight cellular
concrete), concrete block, plywood
less than 25.4 mm (1 inch) thick, etc.
R Use only the supplied Panasonic AC
adaptor PNLV236.
1
Remove the rear cover by
pressing the upper sides of the
cover (
A ) and sliding it down ( B ).
A
B
2
Attach the rear cover to the wall by
using screws (
1
).
R Place the rear cover with “ UP ”
mark facing upwards.
R
2
37 mm (1 15/32 inches)
2
1
1
UP
UP
10 For assistance, please visit http://shop.panasonic.com/support
Setup
HNS105_(en_en)_0206_ver.111.pdf 10 2017/02/06 12:06:44