operation was confirmed
(page 13).
Inserting the battery
R
USE ONLY a CR2 Lithium battery.
R
Confirm the polarities (
,
).
1
Remove the sensor unit cover.
R
Lift from the indented area (
A
)
and open the sensor unit cover
(
B
).
1
2
2
Insert the battery.
3
Attach the sensor unit cover.
Registering the
window/door sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the window/door
sensor, it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the
[Home
Network]
app.
Using registration buttons
1
Hub:
Press and hold
M
OTHER
DEVICE
N
until the LED indicator
blinks in green.
2
Window/door sensor:
Remove the sensor unit cover and
press and hold
M
N
until the
LED indicator blinks in green
(page 7).
R
When registration is complete,
the hub sounds one long beep.
Note:
R
To cancel without registering the
sensor, press
M
N
on the hub and
on the sensor again.
R
If registration fails, the hub sounds
several short beeps.
Using the app
When you register the window/door
sensor by using the
[Home Network]
app, you can assign a name to your
8
Setup
HNS101AZ_(en_en)_0325_ver.031.pdf 8
2015/03/25 14:20:39
