Panasonic KX-HN7001, Installation Manual

Page: 21 / 64

Camera LED indicators
You can use the LED indicators to confirm the camera’s status.
Camera LED indicator Status
Off R No power
R More than 5 seconds have passed since turning on the
power when the camera is not registered to the access
point
R LED indicator is turned off
*1
Green or amber, blinking quickly -
off for 1 second
Camera is on
*1
Amber, lit
Not registered to the access point
*2
, or signal level is
good
*3
Green, lit Registration successfully completed or signal level is
strong
*3
Green, blinking quickly
Camera is searching for an access point
*1
Red, lit
Registration failed, signal level is weak
*3
, or detecting
motion
*1
Red, blinking quickly
Streaming data
*1
Amber, blinking slowly
Battery is running low
*1
Green, blinking slowly Registration mode, updating
Red, blinking slowly
Camera is out of range of the access point
*1
,
*3
*1 You can configure the camera so that its LED indicator does not light during normal
operation. For more information, refer to the User’s Guide (page 32).
*2 The LED indicator lights in amber for 5 seconds after the power is turned on for the camera.
*3 The signal level (strong, good, weak, out of range) is shown after pressing
M SETUP N for 3
seconds.
For assistance, please visit http://shop.panasonic.com/support 21
Setup
HN7001̲(en̲en)̲0209̲ver.140.pdf 21 2018/02/09 11:33:53