Panasonic KX-FT901CX-B, Service Manual

Page: 71 / 183

Error code table:
TRANS=TRANSMISSION RECEP=RECEPTION
7.5.5.1.7. HOW TO OUTPUT THE JOURNAL REPORT:
1. Press repeatedly until the following is displayed.
2. Press .
3. Press or until the “ JOURNAL REPORT ” is displayed.
4. The report is printed out.
(1) CODE (2) RESULT (3) MODE SYMPTOM Counter-
measure*
PRESSED THE STOP KEY SND & RCV Communication was interrupted by the STOP button.
DOCUMENT JAMMED SND The document paper is jammed.
NO DOCUMENT SND No document paper.
PRINTER OVERHEATED RCV The thermal head is overheated.
PAPER OUT RCV Out of thermal paper or the cover is open.
28 COMMUNICATION ERROR SND & RCV -
40 OTHER FAX NOT RESPOND SND Transmission is stopped when the T1 TIMER expires.
41 COMMUNICATION ERROR SND DCN is received after DCS transmission. 1
42 COMMUNICATION ERROR SND FTT is received after transmission of a 2400BPS training signal. 2
43 COMMUNICATION ERROR SND No response after post message is transmitted three times. 3
44 COMMUNICATION ERROR SND RTN and PIN are received. 4
46 COMMUNICATION ERROR SND No response after FTT is transmitted. 5
48 COMMUNICATION ERROR SND No post message. 6
49 COMMUNICATION ERROR SND RTN is transmitted. 7
50 COMMUNICATION ERROR SND PIN is transmitted (to PRI-Q). 8
51 COMMUNICATION ERROR SND PIN is transmitted. 8
52 COMMUNICATION ERROR SND Reception is finished when the T1 TIMER expires. 8
53 ERROR-NOT YOUR UNIT RCV DCN is received after transmission of NSC and DTC. 9
54 ERROR-NOT YOUR UNIT RCV DCN is received after transmission of NSC . 10
57 COMMUNICATION ERROR SND 300bps error 11
58 COMMUNICATION ERROR RCV DCN is received after FTT transmission. 12
59 ERROR-NOT YOUR UNIT SND DCN responds to a post message. 13
64 COMMUNICATION ERROR SND Polling is not possible. 14
68 COMMUNICATION ERROR RCV No response at the other party after MCF or CFR is transmitted. 15
70 ERROR-NOT YOUR UNIT RCV DCN is received after CFR transmission. 13
72 COMMUNICATION ERROR RCV The carrier is cut when the image signal is received. 13
FF COMMUNICATION ERROR SND & RCV Modem error. 12
a. Change the TX speed/RX speed. (Service code: 717/718, refer to SERVICE FUNCTION TABLE (P.43).)
b. Change the transmit level. (Service code: 596, refer to SERVICE FUNCTION TABLE (P.43).)
If the problem remains, see the next page.
71
KX-FT901CX-B / KX-FT903CX-B / KX-FT901CX-W / KX-FT903CX-W / KX-FT901CX-S / KX-FT903CX-S