13 CHECK PROCEDURE (HANDSET)
13.1. Preparation
13.1.1. Equipment Required
·
DECT tester: Rohde & Schwarz, CMD 60 is recommended.
·
Frequency counter: it must be precise to be able to measure 1Hz (precision;±4ppm).
Hewlett Packard, 53131A is recommended.
·
DC power: it must be able to output at least 1A current under 2.4V for Handset, 9V for JIG.
·
Digital multi-meter (DMM): it must be able to measure voltage and current.
·
Oscilloscope
13.1.2. JIGs and PC
·
EEPROM serial JIGs
1. I2C PCB: PQZZTCD705BX
2. RS232C cable: PQZZ1CD705BX
3. Clip cable: PQZZ2CD705BX
4. DC cable: PQZZ3CD705BX
·
PC which runs in DOS mode.
·
Batch file
for PC setting: PQZZTCD410E
13.2. PC Setting
13.2.1. Connections
13.2.2. PC Setting
1. Open a window of MS-DOS mode from the start-up menu.
2. Change a directory to the one with RTX_COM contained.
3. Type
SET RTX_COM=1
from the keyboard (when COM port 1 is used for the connection).
4. Type doskey.
Note:
See the table below for frequently used commands.
Command name
Function
Example
rdeeprom
Read the data of EEPROM
Type rdeeprom 00 00 FF, and the data from
address 00 00 to FF is read out.
readid
Read ID (RFPI)
Type readid, and the registered ID is read out.
writeid
Write ID (RFPI)
Type writeid 00 18 E0 0E 98, and the ID 0018 E0 0E
98 is written.
setfreq
adjust Frequency of RFIC
Type setfreq nn nn.
Getchk
Read checksum
Type getchk.
Wreeprom
write eeprom
Type "wreeprom 01 23 45". "01 23" is address and "45"
is data to be written.
38
KX-TCD410RUM / KX-TCD410RUS / KX-TCD412RUM / KX-TCD412RUS / KX-A141RUM / KX-A141RUS / KX-A142RUM / KX-A142RUS
