9.2.4 Cleaning Mode
Cleaning Mode can be used to help cleaning the conveyor rollers and exit roller. During Cleaning Mode, the
conveyor rollers and exit roller rotate a small amount every time the Start/Stop button (
) on the
scanner is pressed. So, you do not have to rotate the rollers by using your fingers in order to clean the entire
surface of each roller.
For details about operation panel, refer to "5 Operation Panel" (page 20).
Notice
•
Do not touch the conveyor rollers and exit roller while they are rotating.
•
Use Cleaning Mode only to clean the conveyor rollers and exit roller.
1.
Close the ADF door (page 34).
2.
Plug in the power cord.
3.
Turn ON the unit's power (page 32).
4.
Press the menu button (
).
5.
Use or of the cursor button to select "Maintenance".
6.
Press the Enter button (
) to complete your selection.
7.
Use or of the cursor button to select "Cleaning Mode".
8.
Press the Enter button (
) to complete your selection.
•
Cleaning Mode will start.
9.
9.2.4 Cleaning Mode
74
Summary of Contents for KV-S8147
