Panasonic HYBRID IP-PBX KX-TDA200, Features Manual

Page: 23 / 464

Location No.
*1
Name
*2
CLI
*3
Destination
*4
Day Lunch ... Day Lunch ...
0001 123-4567 John White Enable Disable ... 105 100 ...
0002 123-2468 Tom Smith Enable Disable ... 102 100 ...
0003 123-456 A company Enable Disable ... 101 101 ...
: : : : : : : : :
*1
®
12.3 [10-3] DDI / DID Table— DDI / DID Number
®
[451] DID Number
*2 ®
12.3 [10-3] DDI / DID Table— DDI / DID Name
®
[452] DID Name
*3
®
12.3 [10-3] DDI / DID Table— CLI Ring for DDI/DID—Day, Lunch, Break, Night
*4
®
12.3 [10-3] DDI / DID Table— DDI / DID Destination—Day, Lunch, Break, Night
®
[453] DID Destination
Note
Tenant number and VM trunk group number can also be assigned in the DID/DDI table. Tenant number is
used to determine the time mode (day/lunch/break/night) for the corresponding DID/DDI number. VM trunk
group number is used in Voice Mail DPT (Digital) Integration (
®
1.24.3 Voice Mail DPT (Digital)
Integration).
Explanation:
If the DID/DDI number is "123-4567":
1.
Checks the number in the table.
®
Matches the number in location 0001.
2.
Checks the time mode.
In Day mode: CLI is enabled. Route to CLI destination.
In Lunch mode: CLI is disabled. Route to DID/DDI destination, extension 100.
Conditions
•
To use this feature, DID/DDI service must be assigned as the distribution method for a trunk port.
•
DID/DDI Number Modification
It is possible to modify a received DID/DDI number, which may be convenient when programming the DID/
DDI table. The modification method (removed number of digits/added number) can be programmed on a
trunk port basis.
[Modification Example]
Removed number of digits: 6
Added number: 10
Received DID/DDI number: 87654321
Modified DID/DDI number: 876543 21 = 1021
1) Remove the
first 6 digits.
2) Add "10".
•
Inter-digit Time
When the Inter-digit time expires, the PBX stops receiving the DID/DDI number and starts to check the
DID/DDI table. (Refer to the [Programming Example of DID/DDI Table] above).
Even if the Inter-digit time does not expire, the PBX stops receiving the DID/DDI number when the received
number is found in the DID/DDI table. The PBX then routes the call to the corresponding destination. If the
Feature Guide 23
1.1.1 Incoming Trunk Call Features