Panasonic HYBRID IP-PBX KX-TDA100, Pc Programming Manual

Page: 753 / 854

2.16 [9] Private Network
PC Programming Manual 753
2.16.3 [9-3] Network Operator (VoIP)
This screen allows network operators to be programmed. A network operator is an extension at a
remote PBX that will monitor other PBX extensions using Network Direct Station Selection (NDSS).
The settings on this screen should be programmed at the PBX that is to be monitored (Network Data
Transmission for Centralised Operator Feature—Network PBX ID 2–8). Up to 8 network operators
can be programmed.
Network Operator Extension No.
Specifies the number of an extension at the monitor PBX (the PBX whose Network Data
Transmission for Centralised Operator Feature—Network PBX ID is set to 1 in 2.16.2 [9-2]
Network Data Transmission ). Any extension at the monitor PBX can be specified here.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Maintenance Console Location
2.16.3 [9-3] Network Operator (VoIP)
Programming Manual References
2.16.2 [9-2] Network Data Transmission—Network Data Transmission for Centralised Operator
Feature—Network PBX ID
Feature Guide References
1.30.5.1 Network Direct Station Selection (NDSS)
IP-GW Card Slot No. to notify BLF data to Network Operator
Specifies the slot number (with the KX-TDA600, shelf and slot number) of the card used to send
extension status data. This setting is only required when using VoIP to transmit data.
Value Range
For KX-TDA30:
Undefined, 5–7
For KX-TDA100/KX-TDA200:
Undefined, 1–11
For KX-TDA600:
Undefined, 1-1–4-11
Maintenance Console Location
2.16.3 [9-3] Network Operator (VoIP)
Programming Manual References
2.8.1 [1-1] Slot