Panasonic HomeHawk KX-HNC505, User Manual

Page: 104 / 200

R : Indicates areas of the camera image where motion was not detected
R : Indicates areas of the camera image where image detection is disabled
R Tap to change the number of areas displayed on the screen.
5
When finished, tap [Set] .
Motion sensitivity
You can adjust the sensitivity of the camera’s motion detection features.
1
From the [HomeHawk] app home screen, tap
®
[Settings] .
2
Tap [Camera Settings] and select the desired camera.
3
Tap [Detection]
®
[Motion Sensitivity] .
4
Select the desired setting.
–
[High] : The sensors are very sensitive to changes, i.e., even a small change will trigger the
sensors.
– [Normal] : The sensors are moderately sensitive to changes.
– [Low] : The sensors are somewhat sensitive to changes.
– [Very Low] : The image sensor is only slightly sensitive to changes, i.e., a large change is required
to trigger the sensor.
5
When finished, tap [OK] .
Camera SD cards
SD card capacity and total recording time
The following recording times apply when images from one camera are recorded. All times are
approximate.
– 4 GB card: 4 hours
– 8 GB card: 9 hours
– 16 GB card: 18 hours
– 32 GB card: 36 hours
– 64 GB card: 72 hours
– 128 GB card: 145 hours
– 256 GB card: 290 hours
– 512 GB card: 582 hours
– 1 TB card: 1165 hours
Note:
R SD cards larger than 1 TB cannot be used.
R The times listed here are calculated theoretically. Actual recording time may vary.
R The times listed here apply during the following condition.
–
[Resolution] is set to [HD (1280x720)] ( “Changing the camera resolution”, Page 112)
R The file system and other information is stored on the SD card, therefore the card’s actual available
capacity will be less than the card’s noted capacity.
104
Using a shelf, floor, and window camera