Part names and functions
Access Point
A
B
F
E
D
C
A
LED indicator
D
DC jack
B
microSD card slot
E
LAN jack
C
M
SETUP
N
F
Reset button
Access point LED indicator
You can use the LED indicator to confirm the access point’s status.
Access point LED indicator
Status
Off
No power, or LED indicator is turned off
Amber, lit
Power on until start up completed
Amber, blinking quickly
IP address is not obtained, or Ethernet cable is not
connected to the router
Green, lit
Power is on (normal operations)
, or registration
completed for the camera or mobile device
Green, blinking slowly
Registration mode, updating
Green, blinking quickly
Obtaining an IP address, or accessing a microSD card
Green, lit
«
Amber, lit
(alternating)
Starting up
Red, lit
Registration failed
*1 You can configure the access point so that its LED indicator does not light during normal
operation. For more information, refer to the User’s Guide (page 31).
*2 It may take some time for the access point to finish starting up.
For assistance, visit www.panasonic.ca/english/support
17
Setup
HN7051C_(en_en)_0319_ver.040.pdf 17
2018/03/19 19:00:12
