13
VQT3J15
∫
Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
A
Insert the battery until it clicks and locks.
∫
Charging the battery
A
DC input terminal
1
Connect the AC adaptor to the DC input
terminal.
2
Connect the AC cable to the AC
adaptor, then the AC outlet.
≥
The status indicator will flash red at an
interval of 2 seconds, indicating that
charging has begun.
It will turn off when the charging is
completed.
∫
Inserting/removing an SD card
≥
Check that the access lamp has gone off.
1)
Open the SD card cover and insert
(remove) the SD card into (from) the
card slot
B
.
≥
Face the label side
C
in the direction
shown in the illustration and press it
straight in as far as it will go.
≥
Press the center of the SD card and then
pull it straight out.
2)
Securely close the SD card cover.
≥
Securely close it until it clicks.
Quick Guide
Access lamp [ACCESS]
A
≥
When this unit is accessing the SD
card or built-in memory, the access
lamp lights up.
HDC-SD80_TM80_HS80-P-VQT3J15_mst.book 13 ページ ２０１１年１月５日 水曜日 午後２時５１分
