Answering the baby monitor
n
When monitoring with a unit:
Handset:
Press
M
N
to answer a call.
Base unit:
Press
MZN
to answer a call.
If you want to respond from the monitoring
unit, press
M
MUTE
N
.
R
The monitoring unit will answer calls
automatically when the auto intercom
feature is set to
“
On
”
(page 32).
Note:
R
If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds.
– To answer the call with the handset,
press
M
OFF
N
, then press
M
N
.
– To answer the call with the base unit,
press
MZN
3 times.
*1 If
M
MUTE
N
is pressed, press
MZN
2
times.
n
When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press
#1
using tone dialing.
You can turn off the baby monitor feature
by pressing
#0
.
Note:
R
The unit disconnects the call
automatically after 2 minutes.
Other programming
Changing the handset name
The default handset name is
“
Handset 1
”
to
“
Handset 6
”
. You can customize the name
of each handset (“Bob”, “Kitchen”, etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 58).
Handset
1
M
MENU
N#104
2
Enter the desired name (10 characters
max.).
a
M
SAVE
N
a
M
OFF
N
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is
“
Off
”
.
Handset
1
M
MENU
N#105
2
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R
See page 5 for information on the available
model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
Handset:
M
MENU
N#130
MbN
:
“
Panasonic DECT
”
a
M
SELECT
N
2
Base unit:
Press and hold
M
LOCATOR
N
for about 5
seconds.
R
If all registered handsets start ringing,
press
M
LOCATOR
N
again to stop, then
repeat this step.
3
Handset:
Press
M
OK
N
, then wait until a long beep
sounds.
58
For assistance, please visit http://shop.panasonic.com/support
Programming
KX-TG885SK(en)_1215_ver040.pdf 58
12/15/2017 5:04:14 PM
