Panasonic Grid-EYE, User Manual

Page: 7 / 48

6
User Manual Grid-EYE Evaluation Kit
WARNING

The jumper shunt for the pin-header designated J18 must not be placed on the
pin-header prior to using the board, unless the intent is to access the
Bootloader.

The Grid-EYE board has Arduino headers soldered on for convenience, should
the user choose to host the board onto an Arduino (DUE) mother board. Users
are reminded to be careful so not short-out the pins or have the board resting
on a conductive surface.
2.2.1 Grid-EYE Sensor
Specification Value
Power voltage 3.3V ±10%, 5V ±10%/
Current consumption 4.5mA (normal), 0.8mA (standby), 0.2mA (sleep)
View angle 60 degrees (x,y)
Absolute temperature accuracy High gain: ±2.5
o
C (typ.)
Low gain: ±3.0ºC (typ.)
Noise Equivalent Temperature
Difference 0.5°C @ 10Hz
Frame rate (selectable): 1 frame/sec or 10 frames/sec
External interface I
2
C (12bit)
Operation mode Normal, Standby, Sleep (Selectable)
Number of Pixel 64 - (Vertical 8 × Horizontal 8 Matrix)
Grid-EYE Sensor options:
Whilst the Evaluation Kit hosts and demonstrates capabilities of the 3.3V, Low Gain device,
the user has the following options available for design-in and application:

3.3V high gain

3.3V low gain

5V high gain

5V low gain