6
CAUTION
- Use the neutral detergent only.
- For residential use only.
- The minimum distance between supporting surface for the cooking vessels on the hob and lowest part of the Range Hood
must be at least 24 13/32" (620 mm).
- To reduce risk of fire and to properly exhaust air, be sure to duct air outside.
- Before the appliance is put into operation, all the protective film must be removed.
- Check whether the Range Hood is installed securely and horizontally.
- Always operate the Range Hood when using gas cooker.
- Avoid parts from falling when detaching it for cleaning.
- Ensure that the wires inside the Range Hood are not disconnected or cut:
in the event of damage, contact your nearest Servicing Department.
- When disconnect the Power Plug, hold the plug itself. Do not pull the cord anyway.
The cord may be damaged, it may cause fire or electric shock.
- Be sure to disconnect the Power Plug from the wall outlet or switch off the breaker when not using for a long time.
- Product must be installed on the cabinet, which is strong enough to hold the unit. Reinforce it if necessary.
- The Range Hood should be installed so that the metal part of the product and mounting screw do not contact with any metalic item
inside the wall, such as metal laths, wire laths and metal plate, it is possible to cause fire harzards in case of electrical leak.
- During installation, always use personal protective equipment (e.g.: Safety shoes, gloves) and adopt prudent and proper conduct.
- Please wear gloves during the cleaning work.
- Make sure that the electric service supply voltage is AC 120 V, 60 Hz.
- Protect the supply wiring from sharp edges, oil, grease, hot surfaces, chemicals or other objects.
- Suitable for use in a household cooking zone.
- Before installing the Range Hood, check the integrity and function of each part.
Should anomalies be noted, do not proceed with installation and contact the Dealer.
- Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages.
- For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
- It is dangerous to modify or attempt to modify the characteristics of this system.
In the event of malfunctions or if repairs are required to the appliance, do not attempt to solve the problems directly. Repairs
performed by unqualified persons may cause damage. For all repair and other work on the appliance, contact the service centre.
- Insist on original spare parts.
- Do not insert pointed metal objects (cultery or utensils) into any aperture in the Range Hood.
- Do not use a steam cleaner for cleaning the appliance. The steam could reach the electronics, damaging them and causing
short-circuits.
- Do not use too much moisture or water around the push button control panel and lighting devices in order to prevent humidity
from reaching electronic parts.
- Do not clean electrical parts, or parts related to the motor inside the Range Hood, with liquids or solvents.
- Never use petrol, benzene, thinner or any other similar chemicals to clean the product.
- Do not use abrasive products.
- Do not carry out any cleaning operations when parts of the Range Hood are still hot.
- Never use the product in a wet place. It may cause fire or failure.
- During operation, never insert fingers or other objects into any aperture in the Range Hood. Failure or injury may result in.
- Do not put anything on the Range Hood. It may cause fire, failure or injury.
- Do not kink the supply wiring.
- Never use the Range Hood without the metal filters:
in this case, grease and dirt will deposit in the equipment and compromise its operation.
