7
2.Wash and clean grille assembly.
(Use non-abrasive kitchen detergent, wipe dry with
clean cloth.)(Fig.12)
3. Remove dust and dirt from fan body using a
vacuum cleaner. (Fig.13)
1. Remove grille assembly. (Squeeze mounting springs
and pull down carefully.)(Fig.11)
4. Using a cloth dampened with kitchen detergent,
remove any dirt from Fan Body. Wipe dry with
clean cloth. (Fig.14)
5. Replace grille assembly.
WARNING
CAUTION
Fig.12
Fig.13
Fig.14
Ceiling
Vacuum
cleaner
Ceiling
Glove
Fig.11
INSTALLATION FOR FV-07VBB1
3. Insert the grille assembly mounting springs into the
slots as shown and mount grille assembly to fan body .
(Fig.10)
Fig.10
Grille assembly
Grille assembly
Mounting
spring
Slot
Slot
Glove
Glove
Mounting
spring
Fan body
Fig.9
Claw
Rib
Plug connector
Ceiling
2. Secure the blower / motor assembly with 2 screw
and connect the molex plug connector from the
blower to the junction box. (Fig.9)
Before turning on the fan, make sure the
connector is inserted at the correct position.
Failure to properly connect will result in fan not
working.(Fig.9)
The claw of connector must latch to the rib
completely.(Fig.9)
CAUTION
WARNING
The blower / motor assembly must be installed
into housing can tightly by the 2 screw . failure
to secure with screw will affect the grounding.
2 Screw
(ST4.2X8)
Blower / motor assembly
Adaptor
flanges
Ceiling
Fig.8
1. Insert the blower / motor assembly by sliding it into
adaptor flanges. Then press lock the blower / motor
assembly into the housing can until the blower
“clicks” into place for temporary fixation. (Fig.8)
INSTALLATION FOR FV-07VBB1
