STEP 10 (Perform as needed)
STEP 12
STEP 13
STEP 14
STEP 11
Remove the grille blade holder to adjust
orientation of the grille blades to adjust the
direction of warm air flow. (Fig. 8)
Reinstall the grille blade after adjusting the
grille blades.
Fig.8
Grille
Grille blade
holder
Grille
Left figure shows
factory setting.
( )
Grille blades
Attach the grille blades
to the grille with the arrow
mark on the blade in front.
Air
direction
Air
direction
(Factory setting)
Tapping screw
(
4X12)
Grille
Slot
Gloves
Mounting spring
CAUTION
Before turning on the light, ensure that
the connector is in the correct position.
The connector must snap completely
into place.
Mount grille carefully so that lead wire
is not pinched.
Fig.11
Insert the other mounting spring into the
respective slot as shown and mount the grille
to the fan body. (Fig.11)
English
11
Ceiling drywall
IMPORTANT:
Align the arrow marks on the grille blades with
the desired air direction. (The warm
air flow
comes out in the direction of the arrow marks.)
1
2
3
NOTICE
INSTALLATION (NEW CONSTRUCTION) CONTINUED
On the side with the wiring, insert the mounting
spring into the respective slot and connect the
plug to the housing of the lighting unit*. (Fig.10)
*
FV-0511VHL1 only
Pay attention to the orientation of the
grille and the mounting springs.
The grille will only fit to the ceiling in
the proper orientation. (Fig.9)
Adjust Pick-A-Flow™ switch. Refer to
FEATURES on page 6. (Fig.10)
Correct
Fig.9
Grille
Mounting
Spring
Mounting
Spring
Heater
Grille
Heater
Incorrect
Fig.10
Mounting
spring
Lighting
unit
Pick-A-Flow™ switch
Plug connector
Ceiling drywall
Fig.10
