43
Operation Manual
FT1020G3 Rev 2.10.4
6.3
User Level
Each user level type has access to specific menus according to Table 15 below.
Table 15 Levels of access
Information only
Building Officer
Service Personnel
H4 Present system status
H1 Perform monthly test
H1 Perform monthly test
H6 Display faults
H2 Disable or re-enable
H2 Disable or re-enable
H9 Interlocking outputs and inputs
H3 Set calendar and clock
H3 Set calendar and clock
H10 Change password
H4 Present system status
H4 Present system status
H6 Fault acknowledge
H5 Service
H7 Perform zone test
H6 FAULT Acknowledge
H9 Interlocking outputs and
inputs
H7 Perform zone test
H10 Change password
H8 Maintenance
H9 Interlocking outputs and
inputs
H10 Change password
6.3.1
User Level as specified in AS7240.2
The user names and type of access permitted are shown in Table 16.
Table 16 Access Levels and user names
User
level User level type
Required action / equipment Access to
0
None
None (Door closed).
View indications and controls
1
Fire service
personnel
Open door (003 key required).
Fire alarm response via fire
brigade section, fan / damper
control, OWS, hot buttons zone
disablement and buttons on
19” rack display modules.
2A
Information only
003 key + log on as
“Information only”
Same as 1 + keypad.
Menu H4, H6
, H9
2B
Building officer
003 key + log on as “Building
officer”
Same as 2A + keypad.
Menu H1-H4, H6, H7, H9 & H10
3A
Service personnel
003 key + log on as “Service
personnel”
Same as 2B + keypad.
Menu H1-H10
3B
-
003 Key + PC + EBLWin
SSD & S/W download
4
-
003 Key + PC +
special password
SSD & S/W do reset of
alarm counter
6.3.2
User level 0
With the door closed,
no
access, controls indicators are viewed through outer door.
6.3.3
User level 1
After the door has been opened using 003 key ("Door open"
symbol in the symbol
area), the designated user / fire brigade personnel will have access to the following push
buttons
18
Information only, i.e. the faults cannot be acknowledged.
19
Menu H9/C1 only.
Summary of Contents for Firetracker FT1020G3 CIE
Page 1: ...Operation Manual FT1020G3 Rev 2 10 4 For Software V2 10 4 FT1020G3 FDCIE MA430 March 2023...
Page 2: ...This page has deliberately been left blank...
Page 176: ...176 Operation Manual FT1020G3 Rev 2 10 4 Figure 24 FT1020G3 Standard Block Wiring Diagram...
Page 177: ...177 Operation Manual FT1020G3 Rev 2 10 4 Figure 25 FT1020G3 New 5012 PCB Layout...