Panasonic Firetracker FT1020G3 CIE, Operation Manual

Page: 168 / 180

168
Operation Manual
FT1020G3 Rev 2.10.4
31 Change Password (H10)
A password changed via menu H10 (followed by safe shutdown of control unit via H8/S5)
will be valid until it is changed via menu H10 again or it is erased via EBLWin (menu Tools /
Reset user passwords). When a password is required to be changed via EBLWin, a new
SSD download must be downloaded.
Action Text in display Comments
"Menu" According to chapter
"Access", see page 42.
Scroll to menu H10. H10 Change password
"
↲
"
"
↲
" Log in name
Password: 0
New password: Verify:
Enter the old password,
the new password and
again the new pass-
word.
Log in name
Password: ******
New password: ****** Verify: ******
The six digits are
replaced by ****** in the
display.
Incorrect password, NO change
or
Password changed
"ESC"
▒▒▒ menu
H1 Perform monthly test
H2 Disable or re-enable
H3 Set calendar and clock
H4 Present system status
H5 Service
H6 FAULT Acknowledge
H7 Perform ZONE TEST
H8 Maintenance
H9 Interlocking outputs and inputs
H10 Change password
The password is now
changed to the new one.
Scroll to another menu
or press "ESC" or
"Escape menu".
Escape
menu
Note: After change of password, it is recommended to do a "Safe shutdown of the Control
Unit" (see menu H8/S5). This will save the SSW data.