5
3.2.
Trial Operation (after checking Troubleshooting Guide).
3.2.1.
Assembly
• Confirm if there is no gap between housing A and B by pinching lead wires.
• There is no dust or deformation on battery terminals.
3.2.2.
Operation
• Check whether the tool speed increases continuously as the trigger is gradually engaged.
• Check whether the tool operates properly in both the forward and reveres directions.
• Set the LED light to switch-linked mode (L2) and check whether the LED light turns on when the trigger is engaged and that it
turns off when the trigger is released.
• Set the buzzer to each of its three modes and verify that there is no buzzer in b0 mode, that the buzzer sounds when the green
lamp is on in b1 mode, and that the buzzer sounds when the Red lamp is on b2 mode.
• Check whether the ID setting has been properly configured after repair and reassembly.
[ Method of confirmation ]
1. Press D button on the remote control
2. Confirm the operation panel display
• Initializing all settings (revert settings to factory defaults).
[ Setting method ]
3.2.3.
Integrity
• With the switch activated, shake the tool back and forth and up and down and verify that its sound does not change excessively.
