Panasonic EYFLF1XA, Operating Instructions Manual

Page: 77 / 84

‒ 75 ‒
EN EN
[EYFLF]
Setting use interval
Use interval is set to prevent the screwdriver
from continuing its operation when the tool is
automatically stopped due to the implementa-
tion of the torque correction feature. This set-
ting is valid even when the switch is off.
1. Set the tool to the configuration mode.
(See page 71.)
2. Press button D twice.
•The current set value is displayed, and
the main unit panel starts flashing.
Display: U flashing.
Battery capacity indicator: The upper
and lower bars flash.
[Fig.27]
3. Press and as required to change the
time.
Operation Display Seconds
U9 3
U8 2.5
U7 2
U6 1.5
U5 1.2
U4 1
U3 0.7
U2 0.5
U1 0.3
U0 0.1
U OFF
4. Press the OK button to accept the new
setting.
•The control panel stops flashing and
lights up to display the torque clutch
settings.
NOTE:
Check the new value after you change the
settings.
[EYFLF]
Initializing all settings
Factory settings
•Torque clutch setting: “F” (torque control
function off)
• Interval setting: U or 0 (OFF)
• Snug point detection level → L1
• Cross thread reduction function → R0
• Rundown error detecting function → 0
• Tightening time reminder → 0
• Radio signal range limitation function →
C0
• Buzzer setting → b0
• LED light setting → d1
• Speed control setting → P0
• Undetect time setting → J0
•Impact speed setting corresponding to
the length of the socket used → h0
•One-way and two-way communication
function → q0
•This section explains how to revert all tool
settings to their default values at the time of
shipment from the factory.
•The error display will be turned off.
1. Set the tool to the setting configuration
mode. (See page 71.)
2. Press the C button.
The control panel will begin flashing.
Display: The letter “F” flashes on and off.
Battery indication lamp: The upper and
lower bars of the battery flash on and off.
[Fig.28]
3. Press the OK button to accept the select -
ed setting.
The control panel will stop flashing and
light up.
[EYFLF]
Checking Tool Settings
Confirm the set statuses of torque,
snug point determining level,
buzzer, and undetect time setting
Press button A.
The set statuses of torque, snug point deter-
mining level, buzzer, and power-off time
setting (without detection) are displayed in
sequence.