■
HOW TO DISASSEMBLE THE DRIVING BLOCK.
Ref. No. 2C
Procedure 2A
→
→
→
→
2B
→
→
→
→
2C
Removal of the power shaft assembly.
1. Remove the piston applying power spring.
2. Take out the power shaft assembly.
3. Remove the c-type ring, felt and snap ring.
4. Remove the clutch handle with pins and the thrust plate.
5. Remove the snap ring.
6. Slide the jig (plate) into between the washer and the gear case
and hold it by a vise.
7. Tap the top of spindle block with a plastic hammer to take out
the spindle and clutch block assembly.
8. Take out the snap ring on the rear side of the bearing.
9. Take out two pins by using absorption force about 30N magnet
from the clutch block.
10. Take out four steel balls and remove the spindle & piston
assembly.
11. Remove the striker with the O-ring and the O-ring. And take out
the bearing.
12. Take out the piston block. And take out the piston and the
universal coupling.
13. Remove the intermediate shaft assembly.
5
EY6803-X8
