►
Mounting the charger to the wall
1. Attach two screws to
the wall as illustrated.
•
Please be careful as
to not drill a cable or
water pipe in the wall.
2.5mm
28mm
•
Screws and anchors are sold separately. Use no. 6 by 1 in.
round head screws when fixing to wood; or no. 4-6 Molly or
Anchor bolts when fixing to Sheet rock.
2. Hook the charger onto these screws.
3. Plug the power cord into a household outlet.
About the LED display
When the battery
capacity is low
While charging
After charging is
completed
The battery
capacity lamp
blinks.
The charge status
lamp glows.
The charge status
lamp glows.
The battery capacity
lamp blinks.
Use
Using the toothbrush
1
1
Place the brush head firmly
onto the toothbrush shaft.
•
There will be a small gap between
the brush head and the main unit.
2
2
Place the toothbrush in your
mouth before turning it on.
•
Apply a small amount of toothpaste
to the brush head, if desired, before
turning the power on to prevent the
toothpaste from spattering.
3
3
Press the mode selector to select the
mode.
•
Pressing the mode selector toggles the
operation mode between “POWERFUL” and
“SOFT”.
Mode
Description
For standard brushing
Brush moves horizontally only.
When teeth or gums are sensitive.
When brushing in the POWERFUL
mode is too strong.
Brush moves horizontally only.
4
4
While the mode indicator is glowing,
press the power switch to turn on the
main unit.
•
When the toothbrush first starts, the soft-start
function cause it to take about 2 seconds to
reach its normal speed.
5
5
Turn off the main unit when you have finished
brushing.
•
Turn off the main unit before removing it from your mouth to
prevent foam from spattering.
►
Brushing duration notification timer
The timer will signal once at 30-second intervals to indicate the
brushing time for each part of your mouth. It will signal twice at
2-minute intervals to indicate the recommended total brushing
time.
•
It is important to brush each area in the same sequence and
with the same amount of time, every time you brush, to
uniformly brush and clean your teeth.
Use the 30 second brushing duration notification timer wisely
so there will be no missed spot in your mouth.
•
Divide your teeth into 4 parts (upper
and lower, left and right), and brush one
part in order such as “(1) front of the
teeth”, “(2) biting plane of the teeth”,
and “(3) back of the teeth” spending 30
seconds.
Brush the other parts in the same
manner, and brush your whole mouth in
about 2 minutes.
(1)(2)(3)
►
Strong pressure prevention function
Pressing the brush bristles too hard against your teeth will
activate this feature, causing the intensity of the vibration to be
weakened automatically as a safeguard against excessive
pressure.
►
Precaution
•
When you first begin using the toothbrush, you may
experience slight bleeding of the gums even though your gums
may be healthy. This is because your gums are receiving
stimulation by the toothbrush for the first time. The bleeding
should stop after one or two weeks of use. Bleeding that
persists for more than two weeks may be indication of an
abnormal condition of your gums, such as pyorrhea. In this
case, stop using the toothbrush and consult your dentist.
•
Recommended ambient temperature for using is 5 - 35 °C
(41 - 95 °F).
•
Do not allow hair products (e.g., gel or oil) or hand lotion to
come in contact with the unit as they may damage its surface.
Tips on usage
Triple‑edged brush
Place the bristles of the brush gently
against your teeth and move the
toothbrush slowly in a circular motion.
►
For in between the teeth and the gums
Place the bristles at a 45˚ angle.
Place the brush so that the sides of bristles can fit
in between the teeth and gums.
45˚
►
For reaching the far side of the back teeth
Place the brush so that the dense tip bristles can
reach the molars.
►
For the back side of front teeth
Brush vertically.
Move toothbrush to match the angle of the teeth.
Silicon brush
EW‑DL91
►
Brushing direction
•
Place the silicon brush as perpendicular as
possible to your gums.
•
Hold the toothbrush so that the tips of the
bristles of the silicon brush are touching
your gums gently.
•
The brush does not move vigorously over
the gums in the way a toothbrush with
nylon bristles does.
•
Use the
toothbrush
perpendicular to
your gums.
►
Brushing time
•
The recommended use is for approximately 2 minutes, once a day.
•
Focus the brush for 10 to 20 seconds on any areas requiring
particular care.
•
Move the silicon brush slowly throughout the rest of your mouth,
covering all of the gums.
Notes
•
Use the silicon brush gently, as it may break if you pull on it
strongly or bite down on it.
•
Attaching the brush head in the wrong direction may cause
damage to the main unit or the silicon brush.
•
Be careful not to press the silicon brush against your teeth, as
this may damage the silicon brush.
Point brush
EW‑DL91
•
Use in areas where your teeth are
misaligned or in areas that are hard to
reach with a Triple-edged brush.
•
Hold the toothbrush so that the tips of the
bristles are touching your teeth gently.
•
Use the brush
perpendicularly.
•
Move the brush
gently between
your teeth.
After use
Cleaning the main unit and the brush head
►
Main unit
1. Turn off the main unit.
2. Remove the brush head from the main unit.
3. Wash the main unit under running water.
•
Do not rub or damage the waterproof rubber
seal.
•
Do not immerse the main unit under water.
•
Do not wash with water hotter than 40 ˚C (104 ˚F).
►
Brush head
1. Turn off the main unit.
2. Remove the brush head from the main unit.
3. Wash the brush head under running water.
•
Shake well to remove water after washing.
•
Do not pull the bristles of the brush.
•
Do not wash with water hotter than 80 ˚C (176 ˚F).
•
Do not shake the main unit strongly with the
brush head attached.
•
Do not spread the bristles of the silicon brush too
vigorously when washing, as this may damage
the brush.
►
After washing with water
1. Wipe dry with a cloth.
•
Do not charge while it is wet.
2. Return the main unit and the brush head to the
charger.
•
It is recommended to place the brush facing
toward the back of the charger when placing
the brush head on the charger.
►
If the identification ring comes off
Put the identification ring back on.
•
Do not forcibly pull the identification ring
since it can break easily.
•
Using the toothbrush without the
identification ring has no effect on its
performance. The ring is simply for user
identification purposes.
After use
Maintenance
►
Charger
1. Pull the charger cover while pressing
the charger cover release button.
2. Wipe off any dirt on the charger and
the charger cover using a soft cloth.
3. Wipe the prongs of the plug with a dry
cloth about once every 6 months.
Removing the built‑in rechargeable battery
ATTENTION:
A lithium ion battery that is recyclable powers the product you
have purchased. Please call 1-800-8-BATTERY for information
on how to recycle this battery.
Remove the built-in rechargeable battery before disposing of the
toothbrush. Do not dismantle or replace the battery so that you
can use the toothbrush again. This could cause a fire or an electric
shock. Replace it at an authorized service center.
•
Perform steps
1
to
4
, and then remove the battery.
•
Be careful not to short-circuit the negative and positive poles of
the battery.
Specifications
Related voltage:
See the name plate on the product.
(Automatic voltage conversion)
Battery: 1 Lithium-ion battery (3.6 V
; 500 mAh)
Charging time: approx. 12 hours
Changing the brush head (Sold separately)
Replacing the brush head every 3 months is recommended.
If the bristles are bent to one side or worn, the toothbrush is not
effective for brushing. Replace the brush head with a new one.
Part number
Replacement Brush for
EW-DL90/EW-DL91
Quantity
WEW0927
Triple-edged
brush
3
WEW0933
Silicon brush
1
Point brush
1
WEW0911
V-shaped brush
3
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A
TOLL‑FREE (IN USA ONLY) NATIONAL ACCESSORY
PURCHASE HOT LINE AT 1‑800‑332‑5368.
EW-DL90_US.indb 2
2012/06/14 9:59:28
