background image

EN

G

LI

SH

Replacing the Lamp unit

CAUTION:

 

z

When the projector is mounted on a ceiling, do not work with your face close to the 

projector.

 

z

Attach the lamp unit and the lamp cover securely.

 

z

When you experience difficulty in installing the lamp, remove it and try again. If you 

use force to install the lamp, the connector may be damaged.

 

z

Do not use other than designated lamp units.

 

z

Do not lossen other than designated screws.

 

J

Replacement procedure

1)  Turn off the Power by following the 

procedure in "Turning off the projector". 

Unplug the AC power cord. Wait at least 

1 hour and make sure the lamp unit and 

surroundings are cool.

2)  Use a Phillips screwdriver to loosen the 

lamp cover fixing screw and open the 

lamp cover.

 

z

Open the lamp cover, slide the lamp cover in 

the direction of the arow shown in the right 

picture and let the projector stand on the 

side at the same time.

3)  Use a Phillips screwdriver to loosen the 

three lamp unit fixing screws until the 

screws turn freely. Hold the used lamp 

unit by its handles, and pull it gently 

from the projector.

4)  Insert the new lamp unit in correct 

direction. Tighten the three lamp unit 

fixing screws securely with a Phillips 

screwdriver.

5)  Close the lamp cover, and tighten the 

lamp cover fixing screw securely with a 

Phillips screwdriver.

 

z

Close the lamp cover by pushing it slowly 

opposite to the direction of the arrow.

E-3

Lamp cover

fixing screw

Lamp cover

Lamp unit fixing screws

Handles

Note

 

z

When you replace the new lamp unit (ET-

LAE200C), the projector resets the total usage time 

of the lamp unit automatically.

LAMP NO. : ET-LAE200C

Summary of Contents for ET-LAE200C

Page 1: ...cement lamp unit Commercial Use Thank you for purchasing this Panasonic product Before using this product please read the instructions carefully and save this manual for future use Before using this product be sure to read Read this first Page E 2 TQZJ625 1 ...

Page 2: ...let Electric shocks or explosions can result if this is not done When replacing the lamp turn the power off and allow it to cool for at least 1 hour before handling it otherwise it can cause burns Notes on replacing the lamp unit The light source lamp is a glass component If it is hit on a hard object or dropped breakage may occur Be careful when handling a light source lamp A Phillips screwdriver...

Page 3: ... screw and open the lamp cover z z Open the lamp cover slide the lamp cover in the direction of the arow shown in the right picture and let the projector stand on the side at the same time 3 Use a Phillips screwdriver to loosen the three lamp unit fixing screws until the screws turn freely Hold the used lamp unit by its handles and pull it gently from the projector 4 Insert the new lamp unit in co...

Page 4: ...nces contained in the product Part Name Hazardous Substances Pb Hg Cd Cr VI PBB PBDE Projection lamp Mechanical parts This table is prepared in accordance with the provisions of SJ T 11364 Indicates that this hazardous substance contained in all of the homogeneous materials for this part is below the limit requirement in GB T 26572 Indicates that this hazardous substance contained in at least one ...

Reviews: