E-1
WARNING
Remove the power plug before replacing the lamp unit.
■
If the lamp unit is replaced without removing the power plug, electric shocks and breakage may occur.
•
Wait until the lamp is cooled sufficiently before replacing the lamp unit (wait one hour
■
or longer).
The lamp cover gets very hot, and contact with it can cause burns.
•
Do not remove any screws (such as the black screws) other than those indicated
■
when replacing the lamp unit.
If this is not observed, electric shocks, burns or other injuries may occur.
•
Notes on replacing the lamp unit
The light source lamp is a glass component. If it is hit on a hard object or dropped, breakage may occur.
•
Be careful when handling a light source lamp.
A Phillips screwdriver is necessary when replacing the lamp unit and air filter. (Air filters are used only in the PT-
•
DZ570 series)
Hold the screwdriver firmly.
Grip the handle when you remove the lamp unit. Some parts of the lamp unit are sharpened and may cause
•
injury.
Lamp may break. Care should be taken not to shatter the broken glass pieces of the lamp when replacing
•
the lamp unit. If the projector is installed on the ceiling, do not carry out any replacement procedure directly
underneath the lamp unit and keep your face away from the unit.
The lamp contains mercury. Contact the local government office or distributor for the correct disposal of the old
•
lamp unit.
Do not disassemble or modify the lamp unit.
•
NOTICE
For USA only
Hg-LAMP CONTAINS MERCURY, Manage in Accord with Disposal Laws,
See: www.lamprecycle.org or 1-888-411-1996
Read this first!
Always follow these precautions
Accessories
Check that the following accessories are contained.
Air filter (for the PT-DZ570 series)
ET-LAD60A: x 1
ET-LAD60AW: x 2
Dispose of the packaging materials properly after unpacking the product.
•
