background image

TQZH747-6

ET-LAB50

Model No.

Read these instructions completely before replacement.

Information for Users on Collection and Disposal of Old Equipment and 

used Batteries

These symbols on the products, packaging, and/or accompanying 

documents mean that used electrical and electronic products and 

batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and 

used batteries, please take them to applicable collection points, 

in accordance with your national legislation and the Directives 

2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you 

will help to save valuable resources and prevent any potential 

negative effects on human health and the environment which 

could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products 

and batteries, please contact your local municipality, your waste 

disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, 

in accordance with national legislation.

For business users in the European Union

If you wish to discard electrical and electronic equipment, please 

contact your dealer or supplier for further information.

[Information on Disposal in other Countries outside the European Union]

These symbols are only valid in the European Union. If you wish 

to discard these items, please contact your local authorities or 

dealer and ask for the correct method of disposal.

Note for the battery symbol (bottom two symbol examples):

This symbol might be used in combination with a chemical 

symbol. In this case it complies with the requirement set by the 

Directive for the chemical involved.

Lamp unit for LCD Projector

Replacement Instructions

Summary of Contents for ET-LAB50

Page 1: ...aste handling For more information about collection and recycling of old products and batteries please contact your local municipality your waste disposal service or the point of sale where you purchased the items Penalties may be applicable for incorrect disposal of this waste in accordance with national legislation For business users in the European Union If you wish to discard electrical and el...

Page 2: ...fter approximately 10 minutes of operation The steps 7 to 12 after the replacement of the lamp unit should thus be completed within 10 minutes If the LCD projector is operating turn off the power by the following procedure and wait for the lamp unit to cool down before carrying out replacement 1 Hold down the POWER button for at least 0 5 seconds or press the POWER button twice to turn off the pow...

Page 3: ... screws at the bottom of the projector and then remove the lamp unit cover 3 Use a Phillips screwdriver to loosen the two lamp unit fixing screws until the screws turn freely Then hold the handles of the lamp unit and gently pull the lamp unit out from the projector Handles Ⓐ Ⓑ NOTE Be sure to install the lamp unit and the lamp unit cover securely 5 Install the lamp unit cover and then use a Phill...

Page 4: ...ff the power Disconnect the mains lead after the POWER button on the projector illuminates red 12 This will reset the cumulative usage time for the lamp unit to 0 NOTE Press any button other than the POWER button to cancel the LAMP RUNTIME RESET screen Accessory Air filter 1 Printed in Japan NOTE Replace the air filter with the new filter which is supplied as an accessory while referring to the re...

Reviews: