4.2. Self-cleaning recharger
<TROUBLE>
<CHECK>
<REMEDY>
CHECK indicator lamp
<CHECK CARTRIDGE.>
NO
Set the cartridge
blinks.
→
Confirm to set the detergent cartridge properly or reset the detergent cartridge
→
→
→
→
properly.
if it is detached during cleaning.
CHECK indicator lamp
<CHECK WATER TANK.>
NO
Attach the water tank or
is lit.
→
Confirm whether the water tank and its cap is set properly.
→
→
→
→
its cap properly.
And follow the procedure
as shown NOTE 1 down
↓↓↓↓
OK
below.
<CHECK SELF-CLEANING RECHARGER>
NO
Place the self-cleaning
Confirm if the self-cleaning recharger is tilted.
→
→
→
→
recharger on a horizontal
surface.
And follow the procedure
↓↓↓↓
OK
as shown NOTE 1 down
below.
<CHECK WATER TANK.>
NO
Exchange the detergent
Confirm if water over the water feed lower limit line in the tank.
→
→
→
→
cartridge and the cleaning
liquid inside the water
→
→
→
→
tank. And adding water.
↓↓↓↓
OK
<CHECK CARTRIDGE.>
Confirm if the filter is clogged with beard chips.
NO
↓↓↓↓
OK
<CHECK SELF-CLEANING RECHARGER>
NO
Set the water tank cap
Confirm if the cleaning liquid comes out.
→
→
→
→
properly.
And follow the procedure
as shown NOTE 1 down
↓↓↓↓
OK
below.
Set the normal cartridge and the shaver unit and start "CLEAN" course.
If lit;
Replace the self-cleaning
Confirm whether CHECK indicator lamp is still lit or not.
→
→
→
→
recharger.
NOTE 1:
Hold down the SELECT button for approximately two seconds to extinguish the
CHECK indicator lamp.
NOTE 2:
The course will be aborted if the power is cut off during cleaning.
Try to re-operate the course once again to exhaust the cleaning liquid on the cartridge tray.
NOTE 3:
If the cleaning liquid remains the tray even the course is completed normally,
clean the drain and cartridge tray.
9
ES8172-A3 / ES8175-A3 / ES8176-A3
