8.16. Service position
8.16.1. Board checks
1. Connect the main P.C.B and the traverse assembly with an extension cable.
2. Install the traverse assembly to the tilt adjustment jig using three screws and three washers.
Caution:
•
•
•
•
Remove the rubber cushion from the traverse assembly to prevent it from getting damaged.
3. Install a dick on the traverse assembly.
Caution:
•
•
•
•
Make sure the disk is securely installed on the disk motor.
4. Remove the Main P.C.B., Operation P.C.B., Inverter P.C.B., and LCD panel as shown below.
5. The disc cannot be played back with the disc cover attached. Press and hold down the S5201 and S5202 (Secure with cellulose
tape).
22
DVD-LS83E / DVD-LS83EB / DVD-LS83EE / DVD-LS83EG / DVD-LS835EE / DVD-LS86EB / DVD-LS86EE / DVD-LS86EG