3.
For 2-line LCD models:
1.
Select a scanning mode.
OK/SET
2.
Select a destination.
OK/SET
For touch panel models:
1.
Select the destination and scanning mode if necessary.
Note
•
When scanning to email address
, you can enter the destination email address
– see page 59 for character entry.
– pressing the desired station key (1-3).
– pressing
/LOWER
, then press the desired station key (4-6).
*1
One-touch dial equipped models only (
)
If the LDAP setting is activated beforehand (page 131), select
"
LDAP SEARCH
"
or
"
ADDRESS
BOOK
"
.
OK/SET
For LDAP search, enter the name using the dial keypad (up to 11 characters), then press
:
OK/SET
/
:
"
OK
"
to start searching.
4.
If necessary, select the desired binding of the original.
1.
:
/DUPLEX
/
:
"
DUPLEX
"
2.
Select the desired binding of the original.
OK/SET
5.
If necessary, change the scanning settings.
Select the desired setting.
OK/SET
• If you select
"
PASSWORD PDF
"
as the file format, enter a 4-digit password using dial keypad (page 59).
6.
/START
When using the scanner glass,
scan the 1st page.
:
To scan the next page, place the document and press
OK/SET
. Repeat this until all the
documents are scanned, then press
/START
.
:
To scan the next page, place the document and press
"
Scan
"
. Repeat this until all the documents
are scanned, then press
"
Start
"
.
7.
After you finish scanning, press
:
/STOP
/
:
to reset the setting you set in these
procedures.
*1
For 2-line LCD models only. (
)
When using the documents of same width but of different lengths (automatic document feeder only) (
)
Make sure that the following settings are activated in step 5 on "6.2 Scanning from the unit (Push Scan)".
– The scanning mixed size setting is ON.
– The scan size setting is set to the larger document size.
Available formats for scan image save
Scanning mode
TIFF
JPEG
BMP
"
VIEWER
"
"
FILE
"
"
―
"
OCR
―
"
CLOUD
"
6.2 Scanning from the unit (Push Scan)
Operating Instructions
81
