Panasonic DMW-MCTZ35, Operating Instructions Manual

Page: 9 / 160

(ENG) VQT4V81
9
2
Check the O-ring.
•
Check that there is no dirt, sand, hair, dust, salt crystals, lint or grease on
the O-ring. If you find any of these, remove them with a soft, dry cloth.
•
There may be dirt on the O-ring that you cannot see. Check if there is any
dirt by rubbing your finger over the O-ring.
•
Be careful not to leave any fibers from the dry cloth on the O-ring when
wiping it.
•
Check that the O-ring is not ripped, twisted, squashed, frayed or scratched
and that there is no sand sticking to it. Replace the O-ring in these cases.
3
Inspect the O-ring groove.
•
Grains of sand or hardened salt crystals may get into the O-ring groove.
Remove them carefully with an air spray or a cotton swab. If you use a
cotton swab, be careful not to leave any fibers from it in the O-ring groove.
•
Inspect the front case groove as well as the rear case (side where O-ring
is set) groove.
1
Dirt
3
Hair
5
Salt crystals
2 Sand 4 Dust 6 Lint
7
Ripped
9
Squashed
;
Scratched
8 Twisted : Frayed < Sand
1 2 3 4 5 6
7 8 9 : ; <
DMW-MCTZ35&40_PP&E-VQT4V81.book 9 ページ ２０１３年１月７日 月曜日 午後２時７分