- 28 -
Reference
Reference
LED indicators
Error states are indicated by the INFO LED.
Confirm the following items in correspondence to
the state of INFO LED of this unit.
≥
If the state of the INFO LED does not change
after performing the operations in the table
below, contact your local Panasonic dealer.
A
INFO LED
Messages
Check the following when message are displayed
on the screen.
Cannot play.
¾
An attempt was made to play back
incompatible content.
Cannot display on this unit.
¾
You tried to play a non-compatible image.
$
This operation is not available.
¾
Some operations are unsupported by the unit.
IP address is not set.
¾
The “IP Address” in “IP Address/DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Default
Gateway”. (Select the automatic address
acquisition if necessary.)
The current wireless network security setting
is weak. It is recommended to change to a
stronger security setting.
¾
Set a stronger network security level referring
to the wireless router operating instructions.
INFO LED
state
Description
Flashes
6 times
The remote control and this unit
are using different codes.
Turn on this unit by using the
standby/on switch on this unit,
and check “Remote Control
”,
which is displayed on the screen
when you press a button on the
remote control.
Press and hold [OK] and the
displayed number (“
”) for more
than 5 seconds.
Lights up
The USB device is drawing too
much power. Please disconnect
or remove the USB device from
the unit.
The USB device may be
incompatible.
POWER
INFO
