Panasonic DMC-GH3AEB, Service Manual

Page: 59 / 129

59
10 Measurements and Adjustments
10.1. Matrix Chart for Replaced Part and Necessary Adjustment
The relation between Replaced part and Necessary Adjustment is shown in the following table.
When concerned part is replaced, be sure to achieve the necessary adjustment(s).
As for Adjustment condition/procedure, consult the “Adjustment Manual” which is available in Adjustment software.
NOTE:
After adjustments have been terminated, make sure to achieve “INITIAL SETTINGS”.
After updates it to the latest firmware, the adjustment is executed.
*1
• Inspect it, not only corresponding part is replaced, but also camera body is shocked and/or dropped.
• The Panasonic camera body in accordance with the Micro Four Thirds system (DMC-G1 unit, DMC-GH1 unit or DMC-GF1 unit
etc. marketed commodity: operates normal) and a standard zoom lens H-FS014045 (marketed commodity: operates normal) is
required as a reference machine.
• Refer to the adjustment instruction in the adjustment software for details.
*2 NOTE: (When exchange the MAIN P.C.B.)
IMPORTANT NOTICE (After replacing the MAIN P.C.B.)
After replacing the MAIN P.C.B., make sure to perform the “INITIAL SETTINGS” first, then release the “INITIAL SETTINGS” in
order to proceed the electrical adjustment.
NOTE:
1. If electrical adjustment or data re-writing is executed before “INITIAL SETTINGS”, suffix code list is never displayed, and it
cannot be chosen suitable suffix code.
2. Never remove the battery during initial setting in process.
• Correspond by either the following when exchange the MAIN P.C.B. unavoidably by destruction and damage etc. of MAIN