Panasonic DMC-G2EB, Service Manual

Page: 8 / 78

8
3 Service Navigation
3.1. Introduction
This service manual contains technical information, which allow service personnel’s to understand and service this model.
Since this Service Manual does not cover the same part which is already described in the Service Manual Vol.1, when servicing,
refer to the descriptions in the Service Manual for ;
DMC-G2KPP/EB/EC/EG/GC/GD/GH/GT/GK/GN, DMC-G2WEB/EC/EG/GC/GH/GN, DMC-G2EB/EC/EG/GC/GH/GN Vol.1;
Order No.DSC1005028CE.
Please place orders using the parts list and not the drawing reference numbers.
If the circuit is changed or modified, the information will be followed by service manual to be controlled with original service manual.
3.2. Important Notice
*When servicing, it is recommended dealing with Clean box. (Refer to "5.1. Clean Box" section of this service manual for details.)
3.2.1. Camera Body Unit (MAIN P.C.B.)
3.2.1.1. About Mount Box Unit (Ref. 3)
1. This Service Manual does not contain the following repair service information for "MOUNT BOX UNIT"(Ref.3), because it
requires special facilities and equipment.
a. Schematic diagram, Block diagram and P.C.B. layout.
b. Parts list for individual parts.
2. If the "MOUNT BOX UNIT" is confirmed as defective, exchange the "MOUNT BOX UNIT" as a unit (supplied as service parts
size).
3. Before exchange the "MOUNT BOX UNIT", the performances must be carefully checked, by following the "7.Troubleshooting
Guide" section of this service manual Vol.1 (Order No.DSC1005028CE).
Fig. S1
Important:
1. After replacing the MOUNT BOX UNIT, the mount box data has to be stored to the unit.
When the serial number of the mount box unit which is put on the shield plate of mount box unit is entered to the adjustment
unit, the applicable data is stored into the Flash-ROM (IC6007) on the MAIN P.C.B..
Refer to the adjustment instruction in the adjustment software for details.
Fig. S2
2. The full adjustment must be performed after replacing the "MOUNT BOX UNIT", otherwise picture quality can not be meet
with specification.