- 153 -
Others
• Is the [REC]/[PLAYBACK] selector switch at the [
!
] setting?
• Is there any memory remaining on the built-in memory or the card?
>
Delete the pictures which are not necessary to increase the available memory.
• The picture can become whitish if there is dirt e.g. fingerprints on the lens.
>
When it is dirty, lightly wipe the surface of the lens with soft and dry cloth.
• Was this picture taken with the flash at the close range when the zoom was near [W] (1
k
)?
>
Zoom in a little, and then take the pictures.
• Was this a picture taken in [PIN HOLE] in Scene Mode?
>
Check that the exposure is correctly compensated.
• Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
>
Set the [MIN. SHTR SPEED]
to slower speed.
>
Set Auto Bracket
, [FLASH BURST]
in Scene Mode
or [BURST]
of the [REC] Mode menu to [OFF].
• The focus range varies depending on the Recording Mode.
>
Set to the proper mode for the distance to the subject.
• The subject is beyond the focus range of the camera.
• There is camera shake (jitter) or the subject is moving slightly.
• Turn the power on again. If the operations are still not working normally, remove the power and
consult the dealer or your nearest service center.
>
The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures.
>
When taking pictures at a slow shutter speed, use the self-timer.
• Is the number of recordable pictures 2 or less?
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The auto-focus and other operations are not working normally.
The recorded picture is blurred.
The optical image stabilizer is not effective.
Taking pictures using Auto Bracket is not possible.
