9
3.4.2.
INITIAL SETTINGS:
After replacing the Main P.C.B., make sure to perform the initial settings after achieving the adjustment by ordering the following
procedure in accordance with model suffix of the unit.
1. IMPORTANT NOTICE:
Before proceeding Initial settings, make sure to read the following CAUTIONS.
2. PROCEDURES:
• Precautions: Read the above “CAUTION 1” and “CAUTION 2”, carefully.
• Preparation:
- Attach the Battery.
(Since this unit has built-in memory, it can be performed without inserting memory card.)
1. Turn the Power on.
2. Press the [ MODE ] button, and select the [ NORMAL PICTURE ] mode by Cursor buttons, then press the [ MENU/SET ]
button.
3. Turn the Power off.
(If the unit is other than [ NORMAL PICTURE ] mode, it does not display the initial settings menu.)
•
Step 1. The temporary cancellation of “INITIAL SETTINGS”:
Press the [ PLAYBACK ] button, “[ UP ] of Cursor button” and “[ W ] side of Zoom button” simultaneously, turn the Power on.
•
Step 2. The cancellation of “INITIAL SETTINGS”:
Press the [ PLAYBACK ] button in order to enter the [ PLAYBACK ] mode.
Press the [ MENU/SET ] button and “[ LEFT ] of Cursor button” simultaneously, turn the Power off.
The LCD displays the “ ! ” mark before the unit powers down.
•
Step 3. Turn the Power on:
Turn the Power on.
Summary of Contents for DMC-FH10P
