- 7 -
(1) If you use water at a point other than the shower, the water pressure will drop and the water flow may become weak or the hot
water temperature may rise. However, this is not a sign of any trouble. Adjust the hot water temperature to a proper level with the
Hot Water Faucet.
(2) In time of thunder/lightning, switch off the Miniature Circuit Breaker in advance to protect the Shower Body against possible damage.
(3) If the ELB RESET Lever cannot be set even if you push it up or if soon come down during operation, be sure to inform the
matter to the dealer from you purchased the Heater. Never fix the level forcibly with tape etc.
(4) Please do not be alarmed as some water may flow out from the unit during unpacking as the set has been tested with water in
the factory.
(5) Do not remove Power Selector Knob from unit.
(6) Caution:
In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an
external switching device, such as timer or connected to a circuit that is regularly switched on and off by the utility.
(7) When the unit is used by someone such as child, old person, sick person and physically handicapped person, the
concern person is kindly requested to pay attention and check the water temperature by using hand from time to time.
(8) In case of continuous usage at high temperature setting, water temperature will increase and it may cause the control device to
activate temporarily resulting in water temperature to drop.
7. IMPORTANT NOTES /
重要事項
(1)
假如你同一和熱噴水器，水壓將會降低和使到噴水弱或熱水溫度將上昇。無論如何，這並不指示有什麼問題。
請用熱水水龍頭來調整適宜的熱水溫度。
(2)
當雷電交加時，請轉關電流回路斷開器避免熱噴水器整體受到損壞。
(3)
假如
ELB
的復原控制棒不能放置即使你把它推上去或在操作時落下，請確定把此事件通知有關的經銷商。
絕對不能用線帶把它強迫固定。
(4)
在打開包裝之前，請不要擔心一些水份從此熱噴水器流出。
這是因為廠方在產品還未出之前為了保證其操作正常而進行熱水構造的品質檢查所遺留的。
(5)
不能從家庭熱噴水器去除電量調整鈕。
(6)
注意：
為了避免因不慎按到重新設置熱能斷流器所造成的危險，此熱噴水器禁止使用外加調節器，如定時器或連接至定時開關的電路。
(7)
當一些特定人士如小孩、老人、病人或殘障者使用此熱噴水器時，請多留意噴水溫度与時時刻刻用手測試水溫。
(8)
此熱噴水器有特定的持續高溫局限，持續的使用將會啟動溫度控制器而造成花灑水溫下降。
Symptom /
特徽
No hot water comes out from the outlet
at all.
沒有水從熱噴水器流出來。
The water seems to come out with difficulty
噴水流出好像有點困難。
Points to be checked /
檢查事項
(1) Check the following points before asking for repair.
(1)
在還沒有訊問給予修理，請檢查下列重點。
(2) If abnormalities as mentioned below are found during usage, contact nearest Panasonic Water Heater Service Centre
immediately.
1) Water leakage.
3) Water temperature cannot be controlled.
2) No water flow
4) ELB lamp does not light up.
(3) Special skill is required for repairing. Never try to repair the unit by yourself.
1. Check the Filter Unit. Clean the Filter if it is clogged by stain and dirt.
(See picture page 6)
1.
請檢查過濾器組件。清洗過濾器假如已被污染或阻塞（看第六頁）。
1. Check ELB RESET Lever if it is down. (Because ELB is working)
Push up the ELB Reset Lever to reset the ELB.
If it can not be reset, inform the dealer of the matter.
2. Check Main Water Valve. Open the Main Water Valve if it is closed. (See page 4)
1. ELB
的復原控制棒落下時請進行檢查。（因為
ELB
進行操作）
推上
ELB
的復原控制棒。
如
ELB
復原控制棒不能推上，請趕快通知經銷商有關這方面的事項。
2.
檢查水道主水閥，擰開主水閥如已被關上。（看第四頁）。
8. PRODUCT SERVICE /
技術服務
(2)
使用本品時萬一發現下面的各項失常現象，應要立即停止使用，並马上联系邻近的
Panasonic
電熱噴水器服务中心。
1)
漏水。
3)
水溫調整不良。
2)
沒有噴水流出。
4) ELB
指示燈不見點亮。
(3)
上述各項的修理，必須以專門技術員來修理，更不可自己亂弄。
