EN12
HOW TO INSTALL
WARNING
During installation process make sure electric and water supply is turn
"OFF".
Power Control
JET PUMP
Off
High
ELB
Safe
+
-
U-Mode
Set
1
2
3
U-Memory
U-Memory
Figure 1
Figure 2
1.5 m ~
1.7 m
1.
Where to install the Unit.
• Be sure to install the Unit on the wall as illustrated
in Figure 1 (vertical condition only).
• Do not install the Unit away from wall surface as
shown in Figure 2.
• The Unit must be installed at 1.5 m ~ 1.7 m
above the fl oor.
2.
How to remove the Front Plate.
DH-4UD1 & DH-3UD1
Lift up
Front Plate
Screw
Remove the screw at the bottom of the Unit.
Remove the Front Plate by lifting up the bottom side and then
unhook the top side.
DH-4US1 & DH-3US1
Off
High
Power Control
ELB
Front Plate
Power Control Knob
Lift up
Screw
Power Control Knob
Note:
Power Control Knob attached to Front Plate.
Make sure the Power Control Knob is
at
“Off”
condition.
Remove the Screw at the bottom of
the
Unit.
Lift up the Power Control Knob to
make it free (Power Control Knob is
attached to “VR Shaft” inside the Unit).
Make sure the Power Control Knob is
not detached from the Front Plate.
Remove the Front Plate by lifting up the bottom side and then unhook the top side.
3.
How to fi x Electric Home Shower.
250 mm
minimum
250 mm
minimum
25 mm
Ø6 mm
113 mm
170 mm
354.5 mm
Screw
Screw
Wall
Wall
Wall Plug
Figure 1
The distance of the Unit should be more than
250 mm at right and left of the wall.
Make 4 holes in the wall using a drill. The location
of the hole position as shown in the INSTALLATION
TEMPLATE
provided.
Drive a Wall Plug into the hole.
Lead the Flexible Cord to the set thru Portion 1 or 2 as shown below for electric wiring process.
Portion 1:
Portion 2:
Flexible Cord Entry Point
CAUTION
Flexible Cord must enter the Unit thru designated point only
(do not make additional holes).
Summary of Contents for DH-4US1
Page 30: ...MEMO ...
Page 31: ...MEMO ...
