3DQDVRQLF&DQDGD,QF
$PEOHU'ULYH0LVVLVVDXJD21/:7
3DQDVRQLF&RUSRUDWLRQ
Rack
Mounting
Bracket
Mounting
bracket
Stud (Column)
Stud (Column)
900~1000
Anti-drop metal bracket
Mounting bracket
50 or more
Distance between
the mounting
bracket and the
curtain rail
10
30
10 10
21
19
19
21
80
15
Top
Bottom
Fixing bracket
* Do not install the bracket
upside down.
Fix mounting brackets
Same hight between both brackets.
Same hight between both brackets.
Mounting bracket
fixing screw
How to
Install
5.
● Make sure to install the mounting brackets in line with vertical center lines of inner
studs/columns.
● Two mounting brackets should be positioned at the same height against the floor.
(or the rack cannot be installed properly.)
(Unit: mm)
● Fix 2 mounting brackets with 3 screws (truss φ4x40) per
bracket into a stud.
Rack
Mounting
bracket
Rack
chec
k
chec
k
Mounting
Bracket
Operation
ball
①
Pull out the rod by fully pulling the
operation cord with the operation ball.
②
To store the rod, pull the operation
cord on the other side. Make sure the
rack closes.
* Do not stand in front of the rack while
handling the pull cord. The rod may
pop out and cause injuries.
About the rod
* Do not use other rods other than the designated one.
How to mount the rod
5RGVXSSRUW
$UP
URG
… Hold the arm component and place the rod on the rod support.
M
ORRVHQ
N
SUHVV
O
WLJKWHQ
+RZWRVHW
Press the rack slightly against the
mounting brackets and lower the
rack keeping it level. Hook the
rack on the brackets.
Check that it is securely
attached to the brackets.
How to remove the rod
…Hold the arm, then push the rod up.
φ5
Anchor
(Anchors not inlcuded)
About 55mm
3.
Check the rod operation.
1.
Make sure the rack is securely attached to
the mounting brackets
(refer to the finished
drawing above).
2.
Installing the Rack
Post-
installation
check
6.
● Press the rack slightly against the mounting brackets and lower the rack keeping it level. Hook the rack on the brackets securely.
(mounting strength is important.)
(it is important to attach securely to mounting brackets)
Installation
D0414-1104
①
Make a pilot hole using a 5mm drill.
②
Hammer in a specialized concrete anchor and fix with screws.
If a curtain rail/box is more
than 120mm deep
900~1000
More than 10mm
Thickness=
A
-120mm
Effective digging length
to the base
More than 40mm
A
dimension:
Crosspiece
rack
More than 170mm
Sectional
view
(If
A
is more than 120mm)
Depth of curtain rail/box
Plaster board
Crosspiece, at least 1116/170 (not included)
Stud/column
Install a crosspiece to avoid the rail. Otherwise
the curtain rail/ box prevents the rod from
moving properly.
* Make preliminary holes with the screws (min 3 screws/crosspiece) which dig more
than 40mm into the base before fixing. Do not use debris of particle boards.
Concrete anchor (8 pcs • CWFP099)
If installing above a window, before installing, complete the interior
finishing and installation of curtain rails.
2.
Remove the tape from the lid/
operation cord.
(Move the rack back and forth)
Move rack back and forth to ensure it is
securely attached.
3.
Installation of anti drop metal brackets
* Be careful not to damage the wall finish.
● After installing the rack, install the anti drop metal
brackets on the top of the rack (left and right).
(* After installation, please make sure that the rack
does not come off)
Stud (Column)
Rack
Anti drop
metal fitting
Fixing screw for
anti-drop metal
bracket (truss φ4×30
)
Fix to
the stud
Make sure the
bracket is touching
the rack
* Use a specialized concrete anchor, not a general-purpose one.
● Install the rack on an area that will
support its weight. (Do not attach
directly to the plasterboard/ALC)
Improper installation may cause injury
due to falling.
CAUTION
0DNHVXUH
WRREVHUYH
1.
Attaching mounting brackets
Set both ends of the
rod before storing the
rack.
Always install the anti drop brackets to
prevent falling.
The rod may collide with the
rack and cause damage.
Always fix the mounting
brackets to inner columns
(studs). Otherwise these
should be reinforced with
alternatives, like crosspieces.
For concrete walls
(Follow the same steps below for anti-drop metal brackets)
Caution
Caution
Caution
Caution
Caution
Caution
Caution
Rack
Completion drawing
