Panasonic CS-PA7CKE, Service Manual

Page: 49 / 85

EZ8Z+Z! <)%%1&'(%; 'N1 &3M>1 ') 'N1 (%.))-
$%('
1. The inside and outside connecting cable can be connected
without removing the front grille.
2. Connecting cable between indoor unit and outdoor unit
shall be approved polychloroprene sheathed 3 (PC7CKE,
PC9CKE, PC12CKE) or 5 (PA7CKE, PA9CKE, PA12CKE)
x 1.5 mm
2
flexible cord, type designation 245 IEC 57 or
heavier cord. For PA7CKE, PA9CKE, PA12CKE, the
attached wire 6
with two connectors should be applied.
•
Ensure the color of wires of outdoor unit and the
terminal Nos. are the same to the indoor’s respectively.
•
Earth lead wire shall be longer than the other lead wires
as shown in the figure for the electrical safety in case of
the slipping out of the cord from the anchorage.
•
Secure the cable onto the control board with the holder
(clamper).
\DC OD OPQR DSO #:DVO W:FUUR
Please follow the steps below to take out front grille if
necessary such as when servicing.
1. Set the vertical airflow direction louver to the horizontal
position.
2. Slide down the two caps on the front grille as shown in the
illustration at right, and then remove the two mounting
screws.
3. Pull the lower section of the front grille towards you to
remove the front grille.
When reinstalling the front grille, first set the vertical
airflow direction louvre to the horizontal position and
then carry out above steps 2 - 3 in the reverse order.
PSOD /CFO<\ D,R:POFDV
The below operations will be performed by pressing the
“AUTO” switch.
1. AUTO OPERATION MODE
The Auto operation will be activated immediately once the
Auto Switch is pressed.
2. TEST RUN OPERATION (FOR PUMP DOWN/SERVICING
PURPOSE)
The Test Run operation will be activated if the Auto Switch
is pressed continuously for more than 5 sec. to below 10
sec.
A “pep” sound will occur at the fifth sec., in order to identify
the starting of Test Run operation
3. REMOTE CONTROLLER RECEIVING SOUND ON/OFF
The ON/OFF of Remote Controller receiving sound can be
changed over by pressing the “AUTO” Switch continuously
for 10 sec. and above. A “pep”, “pep” sound will occur at the
tenth sec., in order to indicate the “ON/OFF” changed over
of remote control receiving sound.
49
</H,P8<QR Y <SH,P8<QR Y </H,<8<QR Y <SH,<8<QR