33
CQ-RDP383N
30
E
N
G
L
I
S
H
32
CQ-RDP383N
29
E
N
G
L
I
S
H
How to hold the disc
¡
Do not touch the underside of the disc.
¡
Do not scratch on the disc.
¡
Do not bend the disc.
¡
When not in use, keep disc in the case.
Do not use irregularly shaped discs.
Do not leave discs in the following places:
¡
Direct sunlight
¡
Near car heaters
¡
Dirty, dusty and damp areas
¡
Seats and dashboards
Disc cleaning
Use a dry, soft cloth to wipe from the center outward.
Do not attach any seals or labels to your discs.
Do not write anything on the disk label with a pointed pen or
hard-point pen.
Maintenance
Your product is designed and manufactured to ensure the minimum of maintenance. Use a soft cloth for routine exterior
cleaning. Never use benzine, thinner, or other solvents.
Notes on CD/CD Media (CD-ROM, CD-R, CD-RW)
Label side
<Right>
<Wrong>
Do not use irregularly shaped discs.
Notes on CD-Rs/RWs
¡
You may have trouble playing back some CD-R/RW discs recorded on CD recorders (CD-R/RW drives), either due to
their recording characteristics or dirt, fingerprints, scratches, etc. on the disc surface.
¡
CD-R/RW discs are less resistant to high temperatures and high humidity than ordinary music CDs. Leaving them
inside a car for extended periods may damage and make playback impossible.
¡
Some CD-R/RWs can not be played back successfully thanks to incompatibility among writing software, a CD recorder
(CD-R/RW drive) and the discs.
¡
This player cannot play the CD-R/RW discs if the session is not closed.
¡
This player cannot play the CD-R/RW discs which contains other than CD-DA or MP3/WMA data (Video CD, etc.).
¡
Be sure to observe the instructions of CD-R/RW disc for handling it.
If you use commercial CDs, they must have
either of these labels shown at right.
TEXT
Fuse
Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting the
unit directly without a fuse, could cause fire or damage to the unit.
If the replacement fuse fails, contact your nearest authorized Panasonic Service Centre.
Speaker Connections
Caution:
Please follow the instructions given below. Failure to do so will cause damage to the unit and speakers.
¡
Use ungrounded speaker only.
¡
The maximum speaker input should be 50 W or more. (If used with
the optional power amplifier, the speaker input should be higher than
the maximum amplifier output.)
¡
The speaker impedance should be 4 - 8
Ω
.
¡
This unit uses the BTCL circuit, so each speaker should be connected
separately using parallel vinyl insulated cords.
¡
The speaker cords and the power amplifier unit should be kept away
(about 30 cm apart) from the antenna and antenna extension cord.
¡
Never connect the speaker cord to
the body of the car.
¡
Do not use a 3-wire type speaker
system having a common earth
lead.
¡
Do not connect more than one
speaker to one set of speaker
leads. (except for connecting to a
tweeter)
