Page 1-21
REGULAR
MAINTENANCE
1
Check Every 24 Hours (Routine)
1-3-2
Cleaning the Cover Glass for the Line Camera (before Operation)
NOTICE
This maintenance is current-carrying operation. When you open the safety cover,
the power of XY motor is cut. So be sure to open the safety cover to operate.
Clean the cover glass for the line camera. Dust on the cover glass will cause wrong recognition.
1.
Turn OFF the servo switch.
2.
Open the safety cover.
3.
Clean dust on the cover glass for the
upper face of the line camera illumi-
nation.
∗
Be careful not to damage to the shielding plate.
Damage to the shielding plate will cause wrong
recognition.
1-3-3
Cleaning the Tape Feeder Setting Face (before Operation)
NOTICE
This maintenance is current-carrying operation. When you open the safety cover,
the power of XY motor is cut. So be sure to open the safety cover to operate.
Before setting the tape feeder to the table of it, clean the setting face. Foreign body on the setting
face will cause wrong pickup.
1.
Turn OFF the servo switch.
2.
Open the safety cover.
3.
Clean the setting face with the
vacuum cleaner or cleaning brush.
∗
If chip components have dropped on the tape
feeder tables, the tape feeder ski will be
damaged and the pick-up position may be
dislocated. And, what’s worse, pick-up errors
can be increased. Before changing production
models or the tape feeder parts, be sure to
clean there.
Tools
Cloth
Required time
1 minute
OFF ( ) ON ( )
SERVO
Cover glass for the upper face
of the line camera
Tools
Vacuum cleaner , cleaning brush
Required time
1 minute
OFF ( ) ON ( )
SERVO
Setting face
444C-E-MMA01-A03-03
444C-404P
Shielding plate
444C-403P
∗∗∗∗∗
This picture shows the one for CM202-DH.
