![background image](http://html1.mh-extra.com/html/panasonic/cf-w8-series/cf-w8-series_reference-manual_3718505130.webp)
130
Troubleshooting (Advanced)
Cannot communicate with the access point
z
Using the following procedure, confirm whether the computer’s protocol settings are correct (only when using TCP/IP).
A
When
is displayed on the notification area:
Right-click
, and click [Open Network Connections].
When
is not displayed on the notification area:
Click [start] - [Control Panel] - [Network and Internet Connections] - [Network Connections].
B
Right-click [Wireless Network Connection], and click [Properties] - [General] - [Internet Protocol (TCP/IP)] -
[Properties].
C
Confirm the protocol settings, such as IP address, and do the settings properly again.
z
Depending on the access point and settings, access may not be accepted unless the computer’s MAC address is regis-
tered beforehand. In this case, check the computer’s MAC address (
) and register it according to the operat-
ing instructions of the access point.
The communications speed is low
z
Communication speed may decrease if, aside from the access point to which this computer is connected, there is another
access point nearby using the same channel or a similar channel. Change the channel on the connection access point,
and check to see if the speed recovers. Confirm method for changing channels using the access point manual.
z
The communications speed may be reduced for the following reasons. Shorten the distance between the computer and
the access point.
• IEEE802.11g or IEEE802.11b may be affected by a microwave oven or similar, reducing the communications speed
while the microwave oven is in operation.
• IEEE802.11a is more susceptible to interference than IEEE802.11g or IEEE802.11b, and therefore the communications
speed may be reduced if there is a wall between the computer and the access point or if the computer is further away.
z
When using a wireless LAN in an environment that combines both IEEE802.11g and IEEE802.11b, communication speed
when using IEEE802.11g may decrease.
z
Using the CPU Idle Setting to set to [Performance] may improve this problem.
See “A device connected to a PC Card does not operate correctly” (