62
Sleep/Standby or Hibernation Functions
The computer does not enter
sleep/
standby or hibernation immediately after resuming. Wait
approximately one minute.
When the Wake up from wired LAN function is enabled (the function is enabled in the default setting), battery consumption
will increase while in standby or hibernation.
The computer does not enter standby or hibernation immediately after resuming. Wait approximately one minute.
CAUTION
The following problems will occur when you fail the password input (failing three times or leaving the computer unattended
for one minute or more) while resuming from
sleep /
standby or hibernation.
Failing the password input while resuming from hibernation:
• At the next resume, Panasonic boot screen will appear. At this time, do not start the Setup Utility and do not
change settings. Otherwise, resume may not operate correctly.
• Cannot resume from hibernation by the Wake Up from wired LAN function, the Task Scheduler or the operation to
open the display.
Failing the password input while resuming from
sleep /
standby:
• Cannot resume from
sleep /
standby using the USB devices.
To enter sleep/standby or hibernation
1
Close the display, or slide the power switch (A).
Sleep/
Standby: The power indicator (A) blinks green.
Hibernation: The power indicator (A) goes off.
You can alternatively use the Windows menu to enter
sleep/
standby or hibernation.
Click
(Start) -
- [Sleep] / [Hibernate].
Entering/Resuming from Sleep/Standby or Hibernation
Windows 7
Windows XP
Windows XP
Windows 7
Windows XP
Windows 7
Windows XP
Windows 7
Windows XP
<CF-C1 Series>
<CF-S10 Series>
Windows 7
Windows XP
Windows 7
Windows XP
Windows 7