1 1
When needed, the touchscreen can be configured using the following steps.
Configuring the Touchscreen
Make necessary changes
For more information, refer to [Help].
Click [OK]
Touchscreen
2
1
3
N O T E
Select
from the taskbar or select [Settings] from [Start] -
[Programs] - [Updd]
The following screen will appear.
A d v a n c e d
H a r d w a r e
B u t t o n M o d e s
C a l i b r a t i o n
Define the calibration setup.
Use when the cursor can not be pointed correctly with
your finger. (Needed if the alignment of the touchscreen
with the visual image change or adjust the display reso-
lution).
Set the hardware resources.
Match this setting with the
setting for [Touchscreen] in
the Setup Utility.
Set the button modes.
Set the advanced settings.
D e v i c e s
Configure the device controller.
A b o u t
Display the version number.
S t a t u s
Display the status of the controller.
W i n d o w s
Set the “double-click”
settings.
G e n e r a l
Set the general settings and func-
tions.
E v e n t s
Set the events that can be generated
by a controller.
S e t t i n g s
Set the general protocol
settings.
It is also possible to change the double-click speed in [Tap and Buttons] for
[Start] - [Settings] - [Control Panel] - [Mouse]. However, when [Double Click
Speed] in [Mouse] is changed, the double click time in [Windows] is also
changed. In addition, the setting becomes the setting for [Tap and Buttons] in
[Mouse] after the computer is restarted or enters the suspend or hibernation
mode.
page 13
Immediately run [Calibrate] when the number of points of calibration is changed.
N O T E
