21
[For assistance, please call: 1-800-272-7033]
Useful Information
Registration
Follow the procedure below when you want to:
•
Add an additional terminal to your HD-PLC network.
•
Re-register the master and terminal after resetting the master.
1.
Confirm that the mode selector of the master adaptor is set to
MASTER.
2.
Confirm that the mode selector of the terminal adaptor that you want to
register is set to TERMINAL.
3.
Plug the master adaptor and a power strip into the same wall outlet.
•
Registration may not be successful if the master and power strip
are connected to different wall outlets during registration.
•
Make sure the power strip is turned on. Do not use a power strip
with a noise filter or surge protector feature.
4.
Plug the terminal adaptor into the power strip.
5.
Reset the terminal by pressing the FACTORY DEFAULT RESET button
on the terminal for about 3 seconds (see page 20).
•
Check the position of the adaptor’s mode selector (see page 13)
and make sure that you reset the terminal adaptor (not the
master).
6.
Press the SETUP button on both adaptors for about 1 second. The
order in which they are pressed does not matter.
•
The PLC indicator of each adaptor will begin to flash in green.
•
Make sure you press the SETUP button on each adaptor within 3
seconds of each other.
MASTER
TERMINAL
MASTER TERMINAL
MASTER TERMINAL
BL-PA300KTA_OI.book Page 21 Wednesday, August 6, 2008 10:08 AM
Summary of Contents for BL-PA300KTA - High Definition Power Line Communication Ethernet Adaptor Twin
Page 62: ...62 Notes ...
Page 63: ...63 For assistance please call 1 800 272 7033 Notes ...
